Evs XT3 MulticamLSM Version 11.01 - November 2012 Oper Instrukcja Użytkownika Pobierz pdf (Strona 62)

Issue

11.01.D

Multicam - Version 11.01 – Operating Manual

EVS Broadcast Equipment SA – November 2012

GOTO IN and GOTO OUT

You can use Goto IN and Goto OUT functions to jump immediately onto Short IN or

Short OUT points respectively.

9.2.11 Restriping the Timecode of a Clip

Restrictions on the Remote Panel

The function to restripe the timecode of a clip via the Remote Panel is more restricted

than via Multicam on the VGA:

• You cannot choose which timecode type you modify: you will automatically modify the

primary timecode of the clip.

• You cannot modify the date of the clip.

• You cannot modify the type for the primary timecode of the clip.

If you want to modify the date, the type of the primary timecode or the user-defined

timecode, you need to go to the Set Timecode screen in the VGA. For more information,

refer to the section 9.3.12 ‘How to Restripe the Timecode of the Current Clip’, on page

62.

How to Restripe the Timecode of a Clip

To restripe the timecode of a clip on the Remote Panel, proceed as follows:

1. Recall the clip by pressing the corresponding F_ key.

2. Move the jog dial to reach the picture where you want to define a new timecode.

3. Press the MENU key to access the secondary menu.

4. Press SHIFT+C to call the Set TC function.

5. Enter the new timecode for the current picture.

6. In 59.94 Hz modes (NTSC), you can select between Drop Frame and Non Drop

Frame modes by pressing SHIFT+MENU.

7. Press the D key to select CAM or CLIP mode.

• In CAM mode, only the timecode of the camera angle loaded on the primary

channel will be changed.

• In CLIP mode, the timecode of all camera angles of the clip will be changed.

8. Press ENTER to confirm or MENU to cancel.

The primary timecode of the entire clip is updated according to the new timecode value

so that the timecode remains continuous inside the whole clip. Next time this function is

called, the value previously used will be set as default.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 208 209

Brak uwag

Evs XT3 MulticamLSM Version 11.01 - November 2012 Oper Instrukcja Użytkownika Strona 62